Journal cover Journal topic
Atmospheric Chemistry and Physics An interactive open-access journal of the European Geosciences Union
Atmos. Chem. Phys., 11, 1473-1490, 2011
© Author(s) 2011. This work is distributed
under the Creative Commons Attribution 3.0 License.
16 Feb 2011
Oxygen isotopic signature of CO2 from combustion processes
M. Schumacher1,2,3, R. A. Werner3, H. A. J. Meijer1, H. G. Jansen1, W. A. Brand2, H. Geilmann2, and R. E. M. Neubert1
1Centre for Isotope Research, University of Groningen, Nijenborgh 4, 9747 AG Groningen, The Netherlands
2Max-Planck-Institute for Biogeochemistry, Hans-Knoell-Straße 10, 07745, Jena, Germany
3Institute of Plant Sciences, Swiss Federal Institute of Technology Zürich, Universitätsstraße 2, 8092 Zürich, Switzerland

Abstract. For a comprehensive understanding of the global carbon cycle precise knowledge of all processes is necessary. Stable isotope (13C and 18O) abundances provide information for the qualification and the quantification of the diverse source and sink processes. This study focuses on the δ18O signature of CO2 from combustion processes, which are widely present both naturally (wild fires), and human induced (fossil fuel combustion, biomass burning) in the carbon cycle. All these combustion processes use atmospheric oxygen, of which the isotopic signature is assumed to be constant with time throughout the whole atmosphere. The combustion is generally presumed to take place at high temperatures, thus minimizing isotopic fractionation. Therefore it is generally supposed that the 18O signature of the produced CO2 is equal to that of the atmospheric oxygen. This study, however, reveals that the situation is much more complicated and that important fractionation effects do occur. From laboratory studies fractionation effects on the order of up to 26%permil; became obvious in the derived CO2 from combustion of different kinds of material, a clear differentiation of about 7‰ was also found in car exhausts which were sampled directly under ambient atmospheric conditions.

We investigated a wide range of materials (both different raw materials and similar materials with different inherent 18O signature), sample geometries (e.g. texture and surface-volume ratios) and combustion circumstances. We found that the main factor influencing the specific isotopic signatures of the combustion-derived CO2 and of the concomitantly released oxygen-containing side products, is the case-specific rate of combustion. This points firmly into the direction of (diffusive) transport of oxygen to the reaction zone as the cause of the isotope fractionation. The original total 18O signature of the material appeared to have little influence, however, a contribution of specific bio-chemical compounds to individual combustion products released from the involved material became obvious.

Citation: Schumacher, M., Werner, R. A., Meijer, H. A. J., Jansen, H. G., Brand, W. A., Geilmann, H., and Neubert, R. E. M.: Oxygen isotopic signature of CO2 from combustion processes, Atmos. Chem. Phys., 11, 1473-1490, doi:10.5194/acp-11-1473-2011, 2011.
Search ACP
Final Revised Paper
Discussion Paper